Hi folks. I obtained a pre-owned Anycubic Vyper. Alas, every print features defects in the surface as shown in the picture. It occurs in any type of material. Does anybody know the source of this type of defects?
Hi folks. I obtained a pre-owned Anycubic Vyper. Alas, every print features defects in the surface as shown in the picture. It occurs in any type of material. Does anybody know the source of this type of defects?
Weeeeeeell the last time when I tried to replace the hot end, I screwed up so hard the printer was not usable any more after that 😂
How…? Mine is literally 2 bolts and the bowden tube retaining bolt? Plus of course the sensor and resistor cartridge. I have no experience of direct feed hot ends tho.
Guess I have been repeatedly too stupid to buy parts up to specs and then trying to solder them together, which failed. By that, I destroyed the original equipment and got no working replacement in place.