Transcript:

Two panel meme.

Top panel: Woman in the front seat of a car screaming at a child in the rear seat. She’s saying “Why can’t you just shutdown?”

Bottom panel: A child screaming “A stop job is running for Session c2 of user … (1:30 / no limit)”

  • remotelove@lemmy.ca
    link
    fedilink
    arrow-up
    15
    ·
    edit-2
    9 hours ago

    This happens, too. A burst of local brownouts killed an OPNsense firewall of mine once. (The hardware was fine. The data got wrecked.) The firewall would boot, or almost finish booting, and then another brownout would hit. After the third or fourth cycle, the poor thing was toast.

    I should thank the power company for free resilience testing.

      • remotelove@lemmy.ca
        link
        fedilink
        arrow-up
        3
        ·
        2 hours ago

        I did. All the important things have time to gracefully shutdown now. (Except my for my rack of 4 DL360’s, which need something a little more robust than a Walmart UPS. They aren’t critical and only exist to handle weird one-off projects anyway.)

          • Err(()).unwrap()@lemmy.worldM
            link
            fedilink
            arrow-up
            3
            ·
            edit-2
            6 minutes ago

            A blackout is just a loss of power. Nothing complicated about it. There are obvious human and societal consequences, but as far as the infrastructure is concerned, a blackout usually means that protection devices have been tripped and the system has protected itself from greater damage.

            A brownout means that the electric grid (or interconnection), for some reason, can’t supply enough power to satisfy the demand, but protection devices haven’t tripped yet. It can result in momentary power losses, drops in voltage, drops in frequency, or some generators getting desynchronized with the rest of the grid. If reactive loads (like HVAC motors) go offline momentarily, they can cause spikes in power consumption, which can overload circuits and trip safety devices.

            A UPS needs to immediately switch to battery power when there are signs of an imminent power loss. A brownout might cause a consumer-grade UPS to switch on and off repeatedly, which the inverter circuit probably doesn’t like.

            This channel is run by a real civil engineer, he’s released some great videos about the challenges of maintaining an electric grid.

          • sepi@piefed.social
            link
            fedilink
            English
            arrow-up
            3
            ·
            edit-2
            5 hours ago

            If only we could be so lucky. They don’t make Minutemans anymore.

            My house flooded once, had like an inch of water in the living room, and my Minuteman ups was just sitting there beeping cos there was no power.