Hi All!

Recently purchased a Honeywell t6 Pro Z-wave thermostat, and a Zwave dongle to go with it.

I’m running HA in docker, so I spooled up the Z-wave JS UI in a seperate docker container as well. I then added the HA integration for Z-wave and got it talking to the ZwavejsUI

I can tell something went right because the thermostat shows up in the HA integration as “Node 2”, but there aren’t any exposed entities that have anything to do with thermostat functions; It shows things like “node status”, “ping”, etc.

Edit: It also shows up as a “unknown manufacturer” and product in ZwavsJSUI

So something is working… just not as a thermostat.

Any help? I’m a few steps away from returning it and just using a shelly relay to short the two wires together.

  • tburkhol@slrpnk.netEnglish
    3·
    26 days ago

    I have one, and it more or less just showed up. First question: do you have any other zwave devices active & fully functional? There’s a bunch of cheap-ish switches you could get just to validate general network functionality.

    It sounds like you might be in reduced power mode. On the thermostat, there should be a wifi icon top-right. If that icon has a little dot at the bottom, it’s in 24VAC mode without 24 VAC power. From the manual:

    Thermostat is either included in a Z-Wave network but the Z-Wave signal is lost, or is included but AC power is lost (battery used as backup). In this case, Z-Wave radio is turned off to preserve battery life. AC power must be restored or you have to change the power mode. It can be done via excluding thermostat from Z-Wave network and including again in battery power mode where batteries are used as main power source. You can check the actual power mode in the thermostat MENU/DEVICE INFO.

    • batmaniam@lemmy.worldOPEnglish
      3·
      26 days ago

      Unfortunately this is my first and currently only z-wave device; I’ll snag some “fool proof” ones for exactly what you’re saying.

      This is a solid lead and I suspect you’re right! Although some stuff that doesn’t add up:

      • The device isn’t showing the under “wifi” signal icon
      • The device is in “battery mode”, but regarding the procedure to change power mode: It was running on battery during original inclusion, and in fact has never been hooked to AC.

      I think you’ve gotten me on the right track, but I gave myself another wrinkle. I’m also trying to get matter working for the first time, and in the process of troubleshooting a provisioning, I put my unraid server (with HA) to communicate via IP6 only. It now is no longer online and also inaccessible via a directly connected monitor… So I need to solve that before I can do anything else with Z-wave…

      Happy Sunday…

      • tburkhol@slrpnk.netEnglish
        3·
        26 days ago

        Just want to be clear that Honeywell UI uses the wifi icon (4 stacked circle sectors) on the z-wave thermo to indicate z-wave connectivity, not 802.11. If it’s got no such icon on the thermostat itself, then I’d guess that something failed during provisioning, so you ended up stuck with just a couple of parameters.

        Sounds like you’ve got your hands full, either way. Thank god it’s a fun hobby and not a job :) Good luck.

        • batmaniam@lemmy.worldOPEnglish
          1·
          26 days ago

          Re: Icon: Understood, but still grateful for the clarity! Unraid working proper again, I didn’t realize how much there was to Ipv6… another day. Have to take care of some things but succesfully back to baseline. I’ll try repovisioning this evening and see what happens! (I’ll post here for posterity)