Hi folks. I obtained a pre-owned Anycubic Vyper. Alas, every print features defects in the surface as shown in the picture. It occurs in any type of material. Does anybody know the source of this type of defects?

  • wizzor@sopuli.xyzEnglish
    3·
    4 days ago

    Replace the resistor and temp sensor. I would also replace the hot end itself, at least for my printer it was like 10e

    • FUsername@feddit.orgOPEnglish
      1·
      2 days ago

      Weeeeeeell the last time when I tried to replace the hot end, I screwed up so hard the printer was not usable any more after that 😂

      • wizzor@sopuli.xyzEnglish
        1·
        2 days ago

        How…? Mine is literally 2 bolts and the bowden tube retaining bolt? Plus of course the sensor and resistor cartridge. I have no experience of direct feed hot ends tho.

        • FUsername@feddit.orgOPEnglish
          1·
          2 days ago

          Guess I have been repeatedly too stupid to buy parts up to specs and then trying to solder them together, which failed. By that, I destroyed the original equipment and got no working replacement in place.