Truck has shit the bed.
I needed something that would get me to the next town over every day for work for the next few months.
I’m trying really hard to get out of debt so as much as I wanted to just bite the bullet and get a newer, decent, vehicle I ended up buying a junker.
190k miles. Runs okay. Sounds rough but no knocking or ticking. The exhaust has just been jb welded in a few places (which is probably what that weird smell was). Bearing is going out in one of the pulleys.
Brake pedal sinks pretty low before the brakes start to grab. Is this typical for this model?
Anything I need to look out for?


Misfire on cylinder 3, another pending on cylinder 4. Nothing on the emissions stuff yet, but it was a short drive back to the house so it probably hasn’t done the test cycle yet.
Welp, not a big surprise. They overfilled the oil and spilled a little on it, too. That’s annoying. Dealer mentioned they replaced the knock sensor. Speaking of knocking, I heard something periodically tapping against the chassis, like something swinging from a rope. I wonder if it’s that 02 sensor that also is showing as failed.
I guess I know what I’ll be doing this weekend.
Ick, well they definitely cleared those codes right before you picked it up and hoped you wouldn’t notice.
Pull the coils and spark plugs. Look at the spark plug condition, if they’re really burnt and have a wide gap, replace. But what I would also be doing while all 4 plugs are out is a compression test. You can rent one from a parts store or buy from harbor freight. Screw into the spark plug hole, hold throttle wide open, crank for 3 to 5 seconds (or until you hear about 6 compression strokes). Write down resulting compression number for each cylinder.
All cylinders should be within about 5%/5psi of each other in a very healthy engine, and 10%/10-15psi in a moderately worn engine. No cylinder should ever be under 135ish.
I even looked up the Toyota specs, on a new engine just should be 198psi, minimum spec 142psi, max. Difference 14psi.
If you find 3 and 4 are drastically lower, drive that shit right back and tell them to give you your money back because it needs an engine rebuild, probably rings from lack of oil changes.
Edit: https://charm.li/Toyota/2003/Camry Sedan L4-2.4L (2AZ-FE)/Repair and Diagnosis/Maintenance/Tune-up and Engine Performance Checks/Compression Check/Testing and Inspection/
Good plan! I’ll do that. Thanks for looking up that info