I was referring to the waveyness in the center, though the warping on the esges is partly caused by both the oils and the cooling shrinkage, I believe.

The uniform buckling of the layer in the middle of the sheet is what I’m leaning on, but I don’t believe that your fan speed is too high, or there would be more seperation between layers as the filament would cool too much before adhering to the layer below.

I believe there are test STLs that assist in Dialing in your settings for printing plates in particular, but I’m avoiding printing surfaces that large until I get an enclosure built.

I’d say your print time per layer might be too high, aince the filament looks to be contracting off of the plate as it cools. I’d see if there was a way to speed-up the print time of each layer, or break up the plate’s large surface area with holes or other features to dissapate the stress as it cools.

“Dicks out for Jesus Any%” runs, when?

It’s a Chiaotzu!

https://youtu.be/g4GUq60CNeI?t=17

They were always sacrificial pawns. The administration has been salivating over one of them getting killed so that they can invoke Artical 2 and call for martial law.

Text has been a little sluggish with my tests. Might be due to influx of users, though.

Just spit balling here, but they probably tune the AI for different thresholds between return and rent out so that they can rake in the damage fees for things that “weren’t there” during the first AI scan.

I generally reframe it from a perspective even they think they understand: Money.

Governments want their money. Less Population = Less Taxes for them to take, ergo, no government is trying to lower their population. And do they, the audience, think that the government is willing to have less money?

I don’t think so!

It’s what the administration demanded in order to ‘talk to’ Putin about ending the war in Ukraine.